Electrician in Canton, MI for EV Chargers

Electrician in Canton, MI for EV Chargers and Home Upgrades

The new EV is in the garage, and it's charging off a regular outlet at a crawl. Sound familiar? Canton has a lot of homes like yours, and we're the Canton electrician that helps them keep up with how families live now. We serve Canton Township from the Ann Arbor area with EV chargers, service upgrades, basement lighting and generators, with no scheduling fees.

Why Canton Homes Keep Adding Load

Canton Township is mostly subdivision living, with neighborhoods spread across the township between major roads like Ford Road and Michigan Avenue. These homes are newer than what you’ll find in older Wayne County towns, so knob and tube wiring and fuse boxes are uncommon here.

The challenge in Canton is different. Homes built with a certain electrical plan are now asked to run things nobody pictured at the time. Two EVs, a finished basement, a hot tub, a home office and a bigger AC unit can add up quickly. Our job as your Canton electrician is to make room for all of it safely.

EV Charger Installation in Canton

A Level 2 charger is the upgrade most Canton homeowners ask us about. It runs on a 240 volt circuit and typically adds a full day’s driving overnight, which a standard outlet struggles to do. We install all major brands, including the Tesla Wall Connector.

Here’s how an EV charger installation goes with us:

Load check. We look at your panel and run the numbers so the charger won’t overload your service.
Placement. We pick a mounting spot that reaches the charge port without cords across the garage.
Permit and install. We pull the permit, run the circuit and mount the charger.
Inspection and setup. We meet the inspector and make sure the charger is working before we leave.

When the Panel Needs to Grow

Some Canton homes have 100 or 150 amp service. That’s often enough for one EV charger, but a second car, a hot tub and electric heat can push it over. A 200 amp service upgrade gives the home headroom for years of additions. We coordinate the disconnect and reconnect with DTE so you’re without power for as little time as possible.

Lighting Finished Basements

Basements are prime living space in Canton subdivisions, and the difference between a dim storage room and a family room is often the lighting. We add recessed lighting in new and existing ceilings, set up separate zones for TV and game areas and add dimmers so the space works day and night.

If you’re finishing the basement now, we’ll handle the full rough-in, including outlets, dedicated circuits for a bar or gym and interconnected smoke alarms.

Already finished but too dark? Swapping old can lights for slim LED fixtures, or adding a second lighting zone, is a quick project that makes a big difference.

Home Offices and Garage Workshops

Lots of Canton households now include someone working from home, and the spare bedroom office often ends up with a power strip plugged into another power strip. Adding a couple of outlets, a dedicated circuit for computer equipment and better overhead lighting makes the room safer and more comfortable to work in.

Garages are the other hot spot, since many Canton homes have two or three car garages with plenty of wall space. Beyond the EV charger, we wire garages for:

A 240 volt outlet for a compressor, welder or table saw
A dedicated circuit for a second fridge or chest freezer
Bright LED shop lighting on a separate switch
Ceiling outlets for garage door openers and storage lifts
GFCI outlets along the workbench

Hot Tubs and Patio Upgrades

Canton backyards have a lot of patios and decks, and a hot tub is a popular next step. A tub needs a dedicated 240 volt circuit and a GFCI disconnect placed within sight of the tub and a safe distance away from it. If your panel is already full from an EV charger, we’ll figure out the best way to fit both, which sometimes points to a service upgrade.

While the trench is open, it’s easy to add patio lights, a switched outdoor outlet or a circuit for a future outdoor kitchen.

Backup Power for Canton Subdivisions

Many Canton basements depend on a sump pump, and a spring storm that takes out the power can put that finished space at risk. A whole home standby generator restarts the sump, furnace and fridge automatically. We install Generac and Honeywell units, handle the transfer switch and work within any subdivision rules on placement.

A Canton Electrician With Decades of Experience

Current Electrical Systems has been doing residential and light commercial electrical work since 1994. Our electricians are union trained through IBEW Local 252, and we treat your home with respect, from the drop cloths to the final walk-through.

We serve Canton from our base in the Ann Arbor area, Monday through Friday, 6:00am to 4:00pm. Heading north on Sheldon Road? We also work in Plymouth.

Electrician in Canton: Common Questions

Can My Canton Home Handle Two EV Chargers?

Many can, with some planning. We run a load calculation on your home first. Two chargers can often share a circuit using the load-sharing feature built into chargers like the Tesla Wall Connector, or a load management device can pause charging when the house is busy. If the numbers are too tight, a 200 amp upgrade is the next step.

Should I Install My EV Charger Inside the Garage or Outside?

Inside the garage is usually simpler and keeps the charger out of the weather. Outdoor mounting works well if you park in the driveway, as long as the charger and connections are rated for outdoor use. We'll look at where you park, where the panel is and how long the wire run will be.

What Size Generator Does a Typical Canton Home Need?

It depends on what you want to run. Covering essentials like the furnace, fridge, sump pump and some lights takes a smaller unit than running the whole house, including central air. We walk through your priorities, look at your panel and recommend a Generac or Honeywell size that fits.

Can You Add Lighting to a Basement We Already Finished?

Yes. We can add recessed lights, new switches and dimmers to a finished basement ceiling with careful cuts and fishing, and it's easier than most people expect in drywall ceilings. We'll lay out the fixtures first so they avoid joists and ducts and still look evenly spaced.